I have a slideshow with 5 slides. It is a "click to start" with 2 loops.
It scrolls though to slide 5 and then just "disappears" from the page - content lower down in the column just moves up to fill the gap! On refresh of the page, it starts again.
This can be seen on http://www.olivedalerv.co.za/marketplace.html (Handmade dolls by Norma).
When I preview it, it works as intended. When I publish it on a different website, it behaves correctly - see http://www.smartwebsitedesign.co.za/testform.html .
I have tried deleting all content and republishing, but no change.
I cannot attach the rcs file as it is larger than 2mb
Any advice will be appreciated, please.
Nick

The second link you put up goes to 404 page not found
if the file is too big (even after zipped) put it in dropbox & post the link

I have had something similar happen a long time ago,, I think if I remember correctly it was something to do with the in & out animation settings for the last slide, but not 100% sure I also found problems with having the thing loop 2 times,

Try moving the scripts for the slider to the footer area and remove the jquery reference.

Thanks to both of you for your feedback. I will give it a try to move the code!
Thanks
Nick

Hi Eric
I think I did what you advised, but the result was still the same!
Not to worry about further investigation - luckily it is a small project so I created a new one and it works fine.
Thanks again.
Nick